![]() Simultaneous communication via multiple communication channels Pulling the USB cable from the drive while downloading the drive information may require power cycling the drive for further operation.ĥ.2. ) may cause DCT-10 to operate abnormally. Pulling the USB cable from the drive while DCT-10 is communicating to the drive (Read From Drive /Write to Drive, Copy from Network to project. Pulling the USB cable from the drive while communicating may cause DCT10 to operate abnormally. When prompted for the CD Key, check the Install Basic version with limited functionality and the enter “41235356” into the CD Key: window and click Next. If the scan determines that a new version of Microsoft® Windows Installer is required then the installer will install it.Ĥ. The setup program scans your disk for installed components. Close all open applications to prevent additional reboots during setup. Installing DCT-10 Set-up Software To install DCT-10 Set-up Software 1. In DCT-10 Set-up Software Setup dialog box, click Next, and then click Remove on the next dialog. Select DCT-10 Set-up Software and click Change/Remove. Double-click Add/Remove Programs, and then click Change or Remove Programs. From the Start menu, point to Settings, and then click Control Panel. Uninstalling Previous Versions Important: If you have previously installed previous versions of DCT-10 Set-up Software on your computer, you must uninstall those versions before installing DCT-10 Set-up Software: To uninstall previous versions of DCT-10 Set-up Software 1. Administrator privileges are required to Install or Uninstall or update of DCT-10.Ģ.1. ![]() Preparing to Install DCT-10 Set-up Software Before installing DCT-10 Set-up Software, verify that you have met the system requirements and follow the instructions below for preparing to install. Use only an isolated laptop PC connection to the USB port on the drive.Ģ. The USB port is connected to ground on the drive. Standard (Host/Device) USB Cable Note! The USB connection is galvanically isolated from the supply voltage and other high-voltage terminals. USB to RS-422/RS-485 uLink USOTL4 ISOLATED USB/RS-485 CONVERTER MODULE USB to RS485 ADAM 4561 ISOLATED USB/RS-485 CONVERTER MODULE RS232 to RS485 ADAM 4520 ISOLATED RS-232/RS-485 CONVERTER MODULE Recommended hardware/software for communication is as follows: All Editions Serial Communication Microsoft mouse or compatible pointing device VGA (800圆00) or higher resolution display with 16 colors 200 MB of available space required on system driveĬD-ROM or DVD-ROM drive is required for CD versions.1 gigabyte (GB) for working with big project files (50 drives and above)ĭCT-10 Set-up Software disk space requirements:.256 MB or higher recommended Virtual memory requirements:.Windows NT 4.0 (Service Pack 6 or later required)ĭCT-10 Set-up Software RAM requirements: ![]() Windows 2000 Professional (Service Pack 3 or later required) System Requirements All Editions Processorģ50 megahertz (MHz) Pentium III-class processor 450 MHz Pentium III-class processor or higher recommended DCT-10 Set-up Software can be installed on any of the following systems: ![]() GE AF-6 Series DCT-10 Drive Control Tool Software This document contains notes for installing the DCT-10 Drive Control Tool Software 2.32 downloaded from 1. GE Consumer & Industrial Electrical Distribution ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |